Block Printed Wrapping Paper

Last year we enjoyed printing Christmas & thank you cards with my eldest daughter’s designs, so this year we had a go at printing wrapping paper. This was a great project that we could all get involved with. My four year old did the design this time; a sweet reindeer drawing that made a great print.

 
Materials

1 roll of Plain wrapping paper

Block printing ink

Ink tray

Lino cutter

Ink roller /brayer 

Lino sheet

Paper

Pencil

Marker pen

Wooden block (cut to size of design)

Strong craft glue

1. Draw out a design. Using a thick marker pen on the lino.

2. Cut out the areas around the marked section. Trimming off excess lino. Glue to wooden block.

3. Roll out some ink and apply a very thin layer to the lino. 

4. Do some test prints for positioning and ink density.


5. Apply a very thin layer of ink after each print for an even finish.

6. Print the red noses. We used a flat crayon dipped lightly in ink but fingertip will do too.

7. Leave to dry.

8. Ready to wrap gifts!

Make a Children’s Apron 

Materials

Oil cloth 

Invisible thread 

Apron tape 150cm

Cotton thread to match rear side of oil cloth

Cotton thread to match apron tape

Paper Scissors 

Fabric scissors 

90/14 machine needle

Teflon machine foot

Pattern paper

Pencil 

Set square 

Sew on Velcro (2cm wide and 7cm length)


1. Draw pattern using set square for straight edges and making the arm curves not to severe otherwise it won’t hem well.

2. When happy with pattern, cut the oilcloth 

3. Cut x3 50cm of apron tape

4. Double fold the end of two of the strips of apron tape and stitch with coordinating cotton

5. Hem the arm curves with a single fold (approx 0.8cm) and stitch in place, using invisible thread in the spool and cotton thread that matches the backside of the oil cloth in the bobbin.

6. Stitch the two unhemmed tapes in position as shown above

7. Stitch the remaining tape to the two points shown above.

8. Hem the remaining edges

9. Change the bobbin thread to the colour that matches the tape. Fold back and stitch all four points where tape is attached 


To make the neck strap adjustable… 

10. Cut the neck strap 11cm up on the right and hem both ends.

 

11. Sew 5cm of the hook side of Velcro to the short part of the strap and sew 7cm of the loop side to the long part making sure they fasten as pictured below.